Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

3800 service-module session won't connect

I always have problems with this when configuring 3845s with a Switching module.

From what I understand, you just need to IP the interface gi2/0, and you're good to go, but I keep getting this:

mdf-rt-01#service-module gi2/0 session

Trying 10.52.240.1, 2130 ...

Here is relevant config:

interface GigabitEthernet0/0

description $ETH-LAN$$ETH-SW-LAUNCH$$INTF-INFO-GE 0/0$

no ip address

shutdown

duplex auto

speed auto

media-type rj45

interface GigabitEthernet2/0

description INTERNAL_ETHERNET_SWITCH_MODULE

ip address 10.52.240.1 255.255.240.0

ip verify unicast source reachable-via rx allow-default

ip helper-address 10.128.5.59

ip helper-address 10.128.5.50

no ip redirects

no ip unreachables

ip nbar protocol-discovery

ip pim sparse-mode

3 REPLIES
Hall of Fame Super Gold

Re: 3800 service-module session won't connect

Which exact module is this? "show diag" if you are not sure.

New Member

Re: 3800 service-module session won't connect

My apologies:

Slot 2:

NME-XD-24ES-1S-P: EtherSwitch SM 24 10/100T PoE + 1 SFP + StackWise Port adapter, 1 port

Port adapter is analyzed

Port adapter insertion time 04:00:11 ago

EEPROM contents at hardware discovery:

Hardware Revision : 1.0

Top Assy. Part Number : 800-25012-02

Board Revision : A0

Deviation Number : 10-1987

Fab Version : 03

PCB Serial Number : FOCxxxxxxx

RMA Test History : 00

RMA Number : 0-0-0-0

RMA History : 00

Product (FRU) Number : NME-XD-24ES-1S-P

Version Identifier : V02

Base MAC Address : 0025.84db.f300

MAC Address block size : 128

EEPROM format version 4

New Member

Re: 3800 service-module session won't connect

Try removing all the config on Gig 2/0 (default interface Gig 2/0) and just put the IP address.

189
Views
0
Helpful
3
Replies