Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

3825 w/ E3/T3 WIC , doesn't show ?

show interface does not show my E3/T3 wic but show ver does :

Cisco 3825 (revision 1.2) with 226304K/35840K bytes of memory.

Processor board ID FTX1136A37U

2 Gigabit Ethernet interfaces

1 Subrate T3/E3 port

DRAM configuration is 64 bits wide with parity enabled.

479K bytes of NVRAM.

62720K bytes of ATA System CompactFlash (Read/Write)

Do I have a bad E3 card ? What would cause it to show in ver but not in interfaces/configure ?

2 REPLIES
Hall of Fame Super Gold

Re: 3825 w/ E3/T3 WIC , doesn't show ?

You should see it with "show diag". Then, most likely you haven't configured "card type" yet.

Hope this helps, please rate post if it does!

New Member

Re: 3825 w/ E3/T3 WIC , doesn't show ?

Show diag can help you out if the wic's are detected by the router. also you need to put this in your config to let the serial interface appear in your show interface command.

card type E3

324
Views
0
Helpful
2
Replies