May I know if the following "NME-16ES-1G" can support the following command :
"channel group 1 mode desirable"
The reason I need this command is because I need to bundle 2 x FE links through Ether Channel technologies. I've been advised by my colleague that the above is the right command to turn on FEC with PAgP support. I've also been told that the following command is not the best one :
"channel-group 1 mode on"
It is because mode "ON" does not negotiated through PAgP... Is that true?
Yes, this module should support the ability to run PAgP on etherchannel so you should be able to enter that command.
When you use "channel-group 1 mode on" this does indeed disable negotiation and permanently turns the etherchannel on. There are differing views on whether this is a good or bad thing. The advantage to using PAgP is that if the the etherchannel does not form the switch will report that fact.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.