We have a 3845 router that I have been tasked with setting up to replace our 2600 and VG200. The problem I am running into is that our WIC-1DSU-T1 cards are not recognized by the 3845. I have IOS version 12.4(11)T loaded on the 3845. when I do a show diag i get:
WIC Slot 1:
WIC module not supported/disabled in this slot
Hardware revision 1.5 Board revision G0
Serial number 31589541 Part number 800-03279-04
FRU Part Number WIC-1DSU-T1=
I can't find documentation anywhere that says for sure that this card is not supported in the 3845. Has anyone got this to work? I don't want to upgrade to the v2 version of the card unless i have to. Thanks in advance.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...