08-07-2012 11:48 AM - edited 03-05-2019 06:48 AM
I have a new 3925 router and it came with 1 VWIC3-4MFT-T1/E1 card installed. I added a 2nd one and although it shows up in inventory, the interfaces do not show up in configuration in any form, interface or controllers. I used to just install a card and it would be recognized, is that no longer supported and is it platform specific or IOS specific?
Thank you
Roy
Solved! Go to Solution.
08-07-2012 11:56 AM
Configyure card type x/y E1 ot T1
08-07-2012 11:56 AM
Configyure card type x/y E1 ot T1
08-07-2012 01:03 PM
Thank you, that did it. My bad; it was right there in front of me the whole time. The router statement said,"card type needed for slot 0/1. I need to slow down and read more carefully.
Thank you
Roy
08-07-2012 02:02 PM
To slow down is always good.
Thank you for the nice rating and good luck!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide