Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

3G connect with Failover

Hi2All

SP is proposing Wireless WAN for backup connectivity for existing Wired connection, i.e 3G connect for branch office connectivity. Recommended router is 1841. Can I get configuration assistance for 3G to act as failover for primary link. 3G connection would be over public network and need to establish ipsec gre tunnel. OSPF is dynamic routing protocol

best wishes

Anthony

1 REPLY
Bronze

Re: 3G connect with Failover

Hi,

You require generic backup interface configuration with "backup commands" on the Cellular interface.

Pls refer the config guide below.

http://www.cisco.com/en/US/docs/routers/access/1800/1861/software/feature/guide/mrwlsgsm.html#wp1237405

The above link gives backup DDR for Cellular interface as primary. But the same approach you can follow to configure the cellular as backup to a primary interface.

Hope it helps...

Regards...

-Ashok.

With best regards... Ashok ----------- Pls kindly rate if helpful or answered your question.
255
Views
0
Helpful
1
Replies
CreatePlease to create content