Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

4500

Dear All,

I am having 4507R chassis in whcih two SUPs are installed .

in case of failure of Redundant SUP,I want to copy the image which is running on Active SUP to my redundant SUP ( at time when new Redundant SUP is installed )

can i get document on same ?

regds,

aman

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Blue

Re: 4500

Hi

From the 4500 configuration guide

"Copying Files to the Standby Supervisor Engine

If you want to manually copy a file from the active supervisor engine to the slot0: device on the standby supervisor engine, use this command:

Switch# copy source_device:source_filename slaveslot0:target_filename

To copy a file to the bootflash: device on a standby supervisor engine, use this command:

Switch# copy source_device:source_filename slavebootflash:target_filename"

Attached is the full link to the 4500 redundancy documentation

http://www.cisco.com/en/US/products/hw/switches/ps4324/products_configuration_guide_chapter09186a0080233f9e.html

HTH

Jon

2 REPLIES
Hall of Fame Super Blue

Re: 4500

Hi

From the 4500 configuration guide

"Copying Files to the Standby Supervisor Engine

If you want to manually copy a file from the active supervisor engine to the slot0: device on the standby supervisor engine, use this command:

Switch# copy source_device:source_filename slaveslot0:target_filename

To copy a file to the bootflash: device on a standby supervisor engine, use this command:

Switch# copy source_device:source_filename slavebootflash:target_filename"

Attached is the full link to the 4500 redundancy documentation

http://www.cisco.com/en/US/products/hw/switches/ps4324/products_configuration_guide_chapter09186a0080233f9e.html

HTH

Jon

New Member

Re: 4500

thanks...

115
Views
5
Helpful
2
Replies
CreatePlease to create content