Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

4507R+E command query

Hi,

I am looking at upgrading our 4503 to the 4507R+E. Just going through the configurations and a couple of commands seemed to have dropped off this release.

1. I can no longer specify encapsulation type on a trunk. Does the 4507 auto sence encapsulation and apply it dynamically?

2. I had dscp trust configuration as below on the 4503, whats the equivilent on the 4507?

qos trust dscp
auto qos voip trust
tx-queue 3
    priority high
    shape percent 33

Thanks

Brendan

1 ACCEPTED SOLUTION

Accepted Solutions

4507R+E command query

Hello Brendan,

1) yes, it would autosense. To see that, you can issue show interface switchport. As ISL is not supported, the only one left out is 802.1q. Cisco made it easy

2) What is the SUP engine you are on? If it's a SUP 6E, then the command is not supported. Below is the link

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps4324/white_paper_c11-539588.pdf

Thanks

Vivek

3 REPLIES

4507R+E command query

Hello Brendan,

1) yes, it would autosense. To see that, you can issue show interface switchport. As ISL is not supported, the only one left out is 802.1q. Cisco made it easy

2) What is the SUP engine you are on? If it's a SUP 6E, then the command is not supported. Below is the link

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps4324/white_paper_c11-539588.pdf

Thanks

Vivek

New Member

4507R+E command query

Thanks Vivek, SUP 7, I take it from your comment the 7 will not supprt the command either. There was concern the switch would overwrite the IP phones dscp tags, will have to run up some traffic captures to see if this is the case on the new gear.

Thanks

Brendan

4507R+E command query

Yes, you are right. Same case with Sup7 as well. By default everything is trusted. Switch wouldn't overwrite the DSCP value learnt from IP Phone, it would simply trust it. You can check that up with a capture though.

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/3.1.1SG/configuration/guide/qos.html#wp1600135

Thanks

Vivek

278
Views
0
Helpful
3
Replies