Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

4700

Hi,

I have four 4700 routers and all of them are 2FE + T1 config. Does 4700 support 3 FE? I remove the WAN card and install 3rd FE card ?

regards

6 REPLIES
Hall of Fame Super Gold

Re: 4700

Recalling from distant times memory, yes. However do not expect the interface to perform at line rate.

A small L3 switch like the 3560 8-ports woul be better for the job.

New Member

Re: 4700

Hi,

Can I apply the "rate limit" to control the bandwidth of 3rd interface FE?

regards

Hall of Fame Super Gold

Re: 4700

You can probably use traffic shaping instead.

The 4700 runs old IOS and certain features are not available.

Hope this helps, please rate post if it does!

New Member

Re: 4700

Hi, any example for traffic shaping? we will have 10M bandwidth. 2.5M is for data. Other is for voice. If the data traffic is over 200K (e.g. 2.7M), it will drop.

regards

Hall of Fame Super Gold

Re: 4700

Hi, configure an ACL that defines you data traffic, under interface configure "shape" command with the wanted traffic amount and ACL.

As an appreciation to those providing answers, please rate useful posts with the scrollbox below!

New Member

Re: 4700

Hi,

we check the interface of router, it has " rate-limit" command. it doesn't have shape command. Does it mean that the "rate limit" to be work?

regards

121
Views
5
Helpful
6
Replies