I currently have a 3620 router and am about to receive 4 T1s from my Service Provider to be configured as MLPPP. I currently have a NM-2FE2W-V2 in Slot 0, so I have to WIC slots availble there. I was thinking about putting a VWIC-2MFT-T1-DI in each of those slots, thereby having my 4 T1s that I need consolidated in 1 NM slot, leaving the other one open for other interfaces. I saw somewhere that the I should be able to have aggregate bandwidth on the WICs on that NM of 8M, but not certain about that. Could anyone tell me for sure if this is an appropriate selection of interfaces and their placement to work properly for MLPPP over these 4 T1s? Thanks!
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...