Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

6500 boot problem

hello guys

i have a 6509 core switch with sup2

my pcmcia storage is 256MB.

but when i insert the disk inot sup slot the device can not detect it,it goes to rommon and nothig will happen.

any idea?

12 REPLIES

Re: 6500 boot problem

New Member

Re: 6500 boot problem

dear mahmod,

in rommon, when i want to boot from slot0: i recieve an error

rommon1>dir slot0:

open:read error...request 0x4 byte, got 0xfffffff

trouble reading device magic number

dir:cannot open device "disk0"

Re: 6500 boot problem

Hi

Can u tell us which SUP u r having.

Thanks

Mahmood

New Member

Re: 6500 boot problem

ya sure

we have supervisor 2

Cisco Employee

Re: 6500 boot problem

Hi Friend,

Can you give a try with "boot slot0:"?

Regards,

Ankur

New Member

Re: 6500 boot problem

dear ankur

i tried boot disk0: and boot slot0:

here is the result:

string is disk0:s222-adventerprisek9_wan-mz.122-18.sxf5.bin

loadprog:bad file magic number: 0x0

boot:cannot load "disk0"

Re: 6500 boot problem

Hi

it seems that u r flash i.e disk0 is corrupted or u r ios is not valid.

Can u format and copy this image in the flash and try to boot.

Thanks

Mahmood

New Member

Re: 6500 boot problem

format with win xp you mean?

cause there is no format command on the rommon

Hall of Fame Super Blue

Re: 6500 boot problem

Hi

I think Mahmood means format on the 6500. Can you get your 6500 to boot up with another IOS or do you have another 6500 running IOS.

The format command is available when the switch is up and running.

Jon

New Member

Re: 6500 boot problem

dear jon

the flash pcmcia is formated by sup2.

if the problem was on format issue the sup couldt detect it or make "dir" command.

i think the format is ok!

please follow up the case with me..

New Member

Re: 6500 boot problem

I had this problem before. I had to put the flash in another like switch, format it in there, but the correct IOS on it, and then put it back in the switch that had the problem. The flash that was on the disk was for a different sup engine. ONce the correct one was on there it worked.

Re: 6500 boot problem

Looks like your PCMCIA card is not supported, it is simply too big:

http://www.cisco.com/en/US/products/hw/switches/ps663/products_tech_note09186a00801a5d58.shtml#topic1

regards,

Leo

505
Views
0
Helpful
12
Replies