Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

6500 switch boot problem

hi guys,

i have a 6509 with sup2.

i want to upgrade the IOS and Catos

but mail problem is when i changes the default pcmcia card with a high capacity pcmcia, the sup wont detect the new pcmcai.

i should say that my boorflash and slot0: dosent have sufficent memory.

regards

  • WAN Routing and Switching
1 REPLY

Re: 6500 switch boot problem

Hi Ehsan,

The Sup2 can have 16/24/64MB external flash, please do check the following documents for more details:

http://www.cisco.com/en/US/products/hw/switches/ps663/products_tech_note09186a00801a5d58.shtml

http://www.cisco.com/en/US/products/hw/switches/ps700/products_configuration_example09186a0080116ff0.shtml

Flash Cards for the Catalyst 6500/6000 Supervisor Engine 1, 1A and 2 have minimum ROMMON, software version, and other requirements. Refer to Catalyst 6000 Family Flash Card Install Note:

http://www.cisco.com/en/US/products/hw/switches/ps708/products_release_and_installation_notes09186a008026a74b.html

HTH,

Mohammed Mahmoud.

150
Views
0
Helpful
1
Replies
This widget could not be displayed.