Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

7200 IOS failure

Hi,

I upgraded my 7206VXR(NPE-400) last night but it somwhow died:

I put the new IOS on for example disk1: but when the router comes up it prompts

"can't read the first file name on disk" and goes to an infinite loop of CPU and memory errors!!!!!!!!!

The files and the DISK itself are okay , I also put another version but didn't make any difference

(the existing IOS was 12.3(20) and I wanted to upgrade to 12.4(13d or 16a).

I'd to bring back to 12.3 at last to have it alive!!!

anybody seen this problem before?!??!

Thx

  • WAN Routing and Switching
1 REPLY

Re: 7200 IOS failure

Could be an incorrectly formatted flash device or an unsupported size.

The url below describes the procedure:

http://www.cisco.com/en/US/products/hw/routers/ps341/products_installation_and_configuration_guide_chapter09186a00807f8e75.html

regards,

Leo

83
Views
0
Helpful
1
Replies