Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

7200 NPE-G2 & IOS 12.4(24)T

Hello!

I have 2 routers 7206VXR, main and standby. HSRP is configured on all interfaces. Routers terminate VTIs on HSRP adresses, on main routers all VTIs are up and on standby all VTIs are down. I upgraded standby router IOS to 12.4(24)T. After reload all my stanby VTI tunnels are up. When I try to create new tunnel, I get:

Router#sh run int tu1

                            ^

% Invalid input detected at '^' marker.

Router#conf t

Router(config)#int tu1

Router(config-if)#

%LINEPROTO-5-UPDOWN: Line protocol on Interface Tunnel1, changed state to up

It looks like a bug. Last working version seems to be 12.4(15)T8

1 REPLY
Hall of Fame Super Silver

Re: 7200 NPE-G2 & IOS 12.4(24)T

Hello Alexander,

we have a pair with c7200p-advsecurityk9-mz.124-20.T.bin that are doing stateful IPSec.

to ben noted version 12.4(19)T we tried was working bad.

Hope to help

Giuseppe

128
Views
0
Helpful
1
Replies
CreatePlease to create content