I'm trying to load a new ios on this device. I have it installed in its disk2: slot. However, it doesn't appear to be loading it. I keep seeing
an alternate boot helper program is not specified (monitor variable "BOOTLDR" is not set) and unable to determine first file in bootflash loadprog: error - on file open boot: cannot load "cisco2-C7200"
I've tried to boot the IOS via tftp but that doesn't work either. I'm now getting the output below when I just try to dir bootflash: or disk2:
Checksum failed on c7200-fslib-m Expected checksum: 294e, calculated checksum: 294d open: file "c7200-fslib-m" not found open(): Open Error = -1 loadprog: error - on file open cannot load the monitor library "eprom:%c7200-fslib-m" from device: boot flashdir: cannot open device "bootflash:"
When I let it run without breaking it into ROMMON mode it just states the above input about bootldr and sits there as I've pasted below....
Readonly ROMMON initialized an alternate boot helper program is not specified (monitor variable "BOOTLDR" is not set) and unable to determine first file in bootflash loadprog: error - on file open boot: cannot load "cisco2-C7200"
System Bootstrap, Version 12.3(4r)T3, RELEASE SOFTWARE (fc1) Technical Support: http://www.cisco.com/techsupport Copyright (c) 2004 by cisco Systems, Inc. C7200 platform with 524288 Kbytes of main memory
Readonly ROMMON initialized string is disk2:c7200-ik9s-mz.122-15.T9.bin
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...