Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

7204 vxr lacp problem

Hi have a problem with the LACP implementatio in a 7204VXR.

I cannot find the LACP commands.

Here the SHOW VER:

Cisco IOS Software, 7200 Software (C7200-IS-M), Version 12.4(21), RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2008 by Cisco Systems, Inc.
Compiled Thu 10-Jul-08 11:36 by prod_rel_team

ROM: System Bootstrap, Version 12.3(4r)T1, RELEASE SOFTWARE (fc1)
BOOTLDR: Cisco IOS Software, 7200 Software (C7200-BOOT-M), Version 12.4(24)T2, RELEASE SOFTWARE (fc2)

I need to combine two gigabitethernet interfaces with LACP but i can't find any lacp commands in my IOS.

Should I update my IOS ? to wich version?

Now my 7204 vxr has the IOS release 12.4(21) and it contains the feature Link  Aggregation Control Protocol (LACP) (802.3ad) for Gigabit Interfaces, so i should be able to use LACP command!

Focusing on the problem: I'm reading the Cisco's document "Configuring  IEEE 802.3ad Link Bundling and Load Balancing"

Enabling LACP
SUMMARY STEPS
1. enable
2. configure terminal
3. interface port-channel channel-number
4. channel-group channel-group-number mode {active | passive}
5. end

In step 4 i have to use the channel-group command but in the port-cahennel interface config i haven't this type of command.

Associating a Channel Group with a Port  Channel
SUMMARY STEPS
1. enable
2. configure terminal
3. interface port-channel channel-number
4. interface type number
5. channel-group channel-group-number mode {active | passive}
6. end

In step 6 I have to use channel-group command but in the gigabitEthernet interface config this command doesn't allow to add the parameter mode {active | passive}

Also i have to use a lot of lacp command that i can't find in any configure mode:

lacp system-priority priority

show lacp sys-id

lacp min-bundle min-bundle

show lacp {number | counters | internal | neighbor | sys-id}

lacp direct-loadswap

Any suggestion?

Thanks to everybody

Max

1 REPLY
New Member

Re: 7204 vxr lacp problem

Hi,

Did you find solution to it? I've googled alot, could not get any such IOS of 7200 series which supports LACP.

--

Jib

1179
Views
0
Helpful
1
Replies
CreatePlease to create content