Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

7204vxr port adapter for channelized STM1 ?

We need a DS3 in Italy. Our local provider says he can only deliver this on an STM1 optical, using a TUG3 of the STM1. Can we use a 7204 VXR STM1-router to terminate this, using a PA-POS-1OC3 ? or do we need to use another port adapter ?

1 REPLY

Re: 7204vxr port adapter for channelized STM1 ?

Hi

You can use the PA-POS-1OC3 for STM1 link in cisco 7204 VXR. In Cisco 7200 VXR routers, port adapter slots are numbered from the lower left to the upper right, beginning with port adapter slot 1 and continuing through port adapter slot 4 for the Cisco 7204VXR

For more detail : http://cisco.biz/en/US/docs/interfaces_modules/port_adapters/install_upgrade/multichannel_serial/pa-pos-1oc3_install_config/6514over.html#wp1039598

Note : Slot 1 is reserved for the supervisor engine. If a redundant supervisor engine is used, it must go in slot 2; otherwise, slot 2 can be used for other modules.

Regards

Chetan Kumar

338
Views
0
Helpful
1
Replies