Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

7206 VXR NPE-G2 Boot problem

Hi, I have replaced router's processing engine NPE-400 with NPE-G2 processing engine .

The router has c7200p-advipservicesk9-mz.124-15.T3.bin IOS on disk2.

I made a basic configuration. I wrote only hostname on the router and saved this configuration.

When I rebooted the router I get "Would you like to enter the initial configuration dialog?(Yes/no)" message.

The router didn't boot with this configuration. I have checked config-register value. it was 0x2102.

How can I solve this problem?

Thanks in advance.

2 REPLIES
Bronze

Re: 7206 VXR NPE-G2 Boot problem

Hi,

I'm not sure but check...

#dir nvram: you should have startup-config file along with other files.

try to save one more time.... or do

#copy running-config nvram:startup-config

I hope this helps....If so pls rate it..

BR

*aijaz*

New Member

Re: 7206 VXR NPE-G2 Boot problem

Hi,

I have already tried these options but it didn't solve my problem.

Thanks for your help.

172
Views
0
Helpful
2
Replies