Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

7206 VXR - WCCP High CPU

7206 VXR NPG-2 - When i enable WCCP, CPU shoot up from 20% to 70%.

Can anyone please let me know which IOS version should i use so CPU utilization not goes high.

I configure basic configuration.

Thanks in Advance

3 REPLIES
New Member

Re: 7206 VXR - WCCP High CPU

what is the output of:

show proc cpu sort | ex 0.00

show version

show run | i cef

New Member

Re: 7206 VXR - WCCP High CPU

Kindly check the attached file, note WCCP is disable right now.

New Member

Re: 7206 VXR - WCCP High CPU

are you terminating PPPoE on the Router ??

beside that you wil have to enable wccp and then type the same command, and tell me the output.

There could be 2 reasons for high cpu utilization, either a bug or cef could be disabled on the input interface, but it will clear the things when you will enable wccp v2 and check the cpu usage.

409
Views
0
Helpful
3
Replies
CreatePlease to create content