Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

7507 GEIP+ VIP4-80 - Microcode Issue

HI,

Running into an issue trying to install a GEIP+ card into a 7507 running IOS 12.4(25) Service Provider, with RSP4's.

The following error is displayed:

{Sep 9 08:45:35.915 CDT: %DBUS-3-SW_NOTRDY: DBUS software not ready for slot 6 after DOWNLOAD, elapsed 24012, status 0x40 -Traceback= 0x404732E8 0x40686530 0x4068A9D8 0x40680B88 0x40680D40 0x40681438 0x40574124 0x40574108

Sep 9 08:45:35.915 CDT: %DBUS-3-WCSLDERR: Slot 6, error loading WCS, status 0x40 cmd/data 0x75 pos 6443142

Sep 9 08:45:35.915 CDT: %UCODE-3-LDFAIL: Unable to download ucode from system image in slot 6, trying rom ucode

Sep 9 08:45:35.919 CDT: %RSP-3-NOSTART: No microcode for VIP4-80 RM7000 card, slot 6

Sep 9 08:45:44.191 CDT: %RSP-3-ERROR: dbus read at 3E841182

}

HELP PLEASE....

1 REPLY
Hall of Fame Super Silver

Re: 7507 GEIP+ VIP4-80 - Microcode Issue

Hello Scott,

try to reseat the GEIP+ it may be not well placed in 7500 bus and all the other messages come from this.

if you have another empty slot I would try also in another slot.

Sometimes it is even possible to hung a C7500 when the insertion is not correct.

However, RSP4 supports GEIP+ we had two installed in C7507 chassis.

Performance are not very good.

Don't expect full rate capabilities

Hope to help

Giuseppe

277
Views
0
Helpful
1
Replies