Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

7600 load balancing

Hi.

If I have CEF enabled on a 7600 routers, its possible to load balance by paquet? how can I acomplish that balance?

Tks

4 REPLIES

Re: 7600 load balancing

RTR1(config-if)#ip load-sharing ?

per-destination Deterministic distribution

I think it depends on SUP. I am using SUP720 3BXL where per destination only is supported.

HTH

Sam

Re: 7600 load balancing

Below command will give you a clear confirmation:

RTR1#show cef state (add capabilities in some platforms)

HTH

Sam

New Member

Re: 7600 load balancing

Thanks Sam

Re: 7600 load balancing

No problems Pedro, glad I could help and learn in the process.

Please remember to rate or tick the solved box so other readers can save time when searching through.

Sam

206
Views
4
Helpful
4
Replies
CreatePlease to create content