Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

7609 IOS Upgrade Problem

I have cisco 7609 with two SUP-720, WISM, and ethernet modules. Currently I have IOS s72033_rp-ADVIPSERVICESK9_WAN-M), Version 12.2(33)SRA5,

Because this IOS is not detecting the WISM. I am trying the IOS s72033-adventerprisek9_wan-mz.122-18.SXF15 that i have successfully installed in 6513 catalyst which also include the WISM. But now same IOS for 7609 is not working for me.

I followed the below mention steps.

copy ftp: disk0:

Address or name of remote host [192.168.1.11]?

Source filename [s72033-adventerprisek9_wan-mz.122-18.SXF15.bin]?

Destination filename [s72033-adventerprisek9_wan-mz.122-18.SXF15.bin]?

Accessing ftp://192.168.1.11/s72033-adventerprisek9_wan-mz.122-18.SXF15.bin...

Loading s72033-adventerprisek9_wan-mz.122-18.SXF15.bin !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

[OK - 63477880/4096 bytes]

copy disk0:s72033-adventerprisek9_wan-mz.122-18.SXF15a.bin slavedisk0

boot system flash disk0:s72033-adventerprisek9_wan-mz.122-18.SXF15a.bin

but no luck. The Router 7609 goes to mointor mode after this.

When i verify the IOS it gave me following error

ATCT-BD-ULV02-7609-01#verify di

7609-01#$0:s72033-adventerprisek9_wan-mz.122-18.SXF15.bin

%Filesystem does not support verify operations

Verifying file integrity of disk0:s72033-adventerprisek9_wan-mz.122-18.SXF15.bin

%WARNING: Signature not found in file disk0:s72033-adventerprisek9_wan-mz.122-18.SXF15.bin.

ATCT-BD-ULV02-7609-01#

00:18:34: %SIGNATURE-4-NOT_PRESENT: %WARNING: Signature not found in file disk0:s72033-adventerprisek9_wan-mz.122-18.SXF15.bin.

00:18:34: %SIGNATURE-4-NOT_PRESENT: %WARNING: Signature not found in file disk0:s72033-adventerprisek9_wan-mz.122-18.SXF15.bin.

and even with old image i m not able to write configuration on standby. I m gettin following error.

ATCT-BD-ULV02-7609-01#

00:09:34: %PCMCIAFS-SP-5-DFS_CLOSE_ERR: Error during close of the file s72033-adventerprisek9_wan-mz.122-18.SXF15.bin. Failed to flush the remaining file data.

ATCT-BD-ULV02-7609-01#

*** Illegal Opcode Exception ***

PC = 0x8010dce0, Cause = 0x28, Status Reg = 0x30409003

00:03:32: %PFREDUN-SP-4-BOOTSTRING_INVALID: The bootfile slavesupboot-disk:/s72033-advipservicesk9_wan-mz.122-33.SRA5.bin is not present in standby

00:03:34: %PFINIT-SP-5-CONFIG_SYNC: Sync'ing the startup configuration to the standby Router. [OK]

Please let me what i m missing and which IOS image required for 7609.

Please also let me know that the steps i used for upgrade are right or not.

3 REPLIES
New Member

Re: 7609 IOS Upgrade Problem

can anybody help me out.

Hall of Fame Super Gold

Re: 7609 IOS Upgrade Problem

You copied a file called "s72033-adventerprisek9_wan-mz.122-18.SXF15.bin" from your FTP to Disk0 without a problem.

But you tried to copy "s72033-adventerprisek9_wan-mz.122-18.SXF15a.bin" from Disk0 to SlaveDisk0. Do you have "s72033-adventerprisek9_wan-mz.122-18.SXF15a.bin" in Disk0?

New Member

Re: 7609 IOS Upgrade Problem

type show disk0: and slavedisk0: or dir disk0: and see if same image is there on both disks, also from rommon try to run the image directly by boot command.. see if it helps

1149
Views
0
Helpful
3
Replies