Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

7609 QOS Config CIR / MIR / PIR

I have a customer that we sold them a 10 Meg point to point ethernet circuit. We had them on a circuit that included several hops on a 15454 and a couple 3560's that we were policing at 10 meg . We cut them to the 7609 we are policing at 10 meg and dropping the packet after that. The 7609 does a much better job policing which caused issues with there network. We are looking to be able to offer them the 10 meg with up to 10% bursting to 11 Meg total. I have been searching and found that there are several options with Cir / Mir / Pir. I was looking for a sample of what the config would look like. Any help would be great.

Jeff

here is what I am using today.

interface GigabitEthernet9/1
description wan
switchport
switchport access vlan 3002
switchport mode dot1q-tunnel
no cdp enable
spanning-tree portfast
spanning-tree bpdufilter enable
service policy input 10x10meg_point_to_point
end


Policy Map 10x10meg_point_to_point_policy
    Class 10x10meg_point_to_point
     police cir 10000000 bc 312500
       conform-action transmit
       exceed-action drop

Class Map match-all 10x10meg_point_to_point (id 5)
   Match access-group name MAC

Everyone's tags (5)
1491
Views
0
Helpful
0
Replies