Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

802.1q on a 2600 series router

I've been wracking my brain on how to enable dot1q on the 2 fastethernet ports in the chassis of the router. No layer 2 networking modules are installed, anyone have any ideas?

1 REPLY
Hall of Fame Super Blue

Re: 802.1q on a 2600 series router

Hi

Are you saying it doesn't work or you don't know the commands. Config example in brief

int fa0/0.10

encapsulation dot1q 10 <- This must match the vlan number

ip address 192.168.5.1 255.255.255.0

int fa0/0.20

etc...

Oobviously the switchport that fa0/0 connects to needs to be configured as an 802.1q trunk.

If you do not have the enacapsulation option available under the subinterface bear in mind you need a minimum of IP Plus to run 802.1q.

HTH

Jon

222
Views
0
Helpful
1
Replies