Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

805 Router

Hey Guys,

I have Cisco 805 Router and connecting a 2 MB Lease line but my serial link line protocol is not comming up. I have tested the link with other 2600 router and the link is working fine.

Is there is any speed issue with 805 Router. I mean does it support 2 MB Link.

Regards,

MAX

3 REPLIES
Silver

Re: 805 Router

Once you are using the correct cable then it should work. If the router cannot support such bandwidth, it will be limited during the packet transfer and still able to let the interface up.

Are you using DCE cable ? You should use DTE cable.

Please advise the cable model no. and the interface type of the CSU/DSU, modem, etc.

Please also provide the router config. for reference.

Hope this helps.

Community Member

Re: 805 Router

Thanks for your reply!

I am using Smart Serial V.35 Cable.

Interface Serial0

ip address x.x.x.x 255.255.255.252

no sh

encapsulation hdlc

When i am doing Show Controller Serial0, i am seeing V.35 cable detected and "clock stopped".

i am also getting a message from the console that "speed exceed 512Kb, port shutdown"

Any suggestion please......

Regards,

MAX

Silver

Re: 805 Router

Sorry I can't find such doc. to tell the actual throughput of 805 and 512kbps is not an usual figure for an async/sync interface.

Can you provide the "show controller" & "show serial 0" ?

150
Views
0
Helpful
3
Replies
CreatePlease to create content