Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

827 NAT Question

Hi, I am trying to configure an 827 running 12.2(8)T5 with static NAT.

The WAN IP is provided via DHCP on the ATM interface and the LAN is connected via Ethernet0 to a 192.168.0.0/24 subnet

I want to forward ALL traffic hitting the WAN interface to IP add 192.168.0.253 on the LAN.

I would usualy use the command

'ip nat inside source static 192.168.0.253 interface Dialer1'

However the 827 does not accept this syntax. I get as far as 'ip nat inside source static 192.168.0.253' but after that it is expecting an inside global address and will not accept 'interface dialer1'

I do not have a static WAN address I can give it. Any ideas?

Many thanks.

Neil.

6 REPLIES
Bronze

Re: 827 NAT Question

Hii..as i understand frm ur post... u basically want to hv the inside n/w to move out the isp interface using nat with atm i/f.

u shud use....ip nat inside source list 1 interface dialer 1 overload.

and define an acl as: access-list 1 permit 192.168.0.0 0.0.0.255 .

ths shld resolve the problem if this is wht is intended.

the statement u hv used is basically a static mapping which needs a global ip to be linked with local ip protocol for traffic redirection, which is not suitable for ur scenario.

Pls do rate the post.

New Member

Re: 827 NAT Question

No that is not what I am trying to achieve. I would like to forward ALL inbound traffic from the internet to a specific internal IP address.

It is a simple setup that even the cheapest routers can achieve but the command I usually use is not accepted on this router.

I did try configuring the router as a transparent bridge but the device behind the router became unstable when the ISP changed the WAN IP address hence why I am trying the NAT method. I can get an 837 to work just not this dam 827.

Bronze

Re: 827 NAT Question

Have you tried: ip nat source static 192.168.0.13 int di1 ?

The only other idea is to try a route-map with NAT. ip nat outside route (routemap name) blah blah blah. . .but I don't know if it'll work.

Can't say I've ever really dealt with NAT and DHCP.

New Member

Re: 827 NAT Question

I have answered my own question.

you need the feature 'NAT - Default Inside Server Enhancement '

Just upgraded the IOS - job done!

Hall of Fame Super Gold

Re: 827 NAT Question

Anyone that answers his own question and takes the time to let others know, deserves appreciation, so I have rated your post!

New Member

Re: 827 NAT Question

I have found the answers to many of my questions on this forum, it is only fair that I contribute.

Thanks for your vote!

112
Views
5
Helpful
6
Replies