I have now been trying to get this fixed for over 8 hours. I have a new cisco 857w I am trying to set it up to connect to a MS ISA 2004 box. The MS box is on the internet and I can get Phase 1 to work ,but the phase two part of the authentication fails. I have changed every single setting I can find , Im nearly 99% sure its the ISA box.
Does anyone have any tips that might not have been mentioned in the 435 different posts I have read today.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...