04-05-2007 05:41 AM - edited 03-03-2019 04:26 PM
Hello,
Does anybody had a problem with bandwidth parameter change after reaload?
I have a Cisco 877 router with AdvIPSer software and such a configuration considering ATM interface:
interface ATM0
bandwidth 256
no ip address
load-interval 30
no atm ilmi-keepalive
dsl operating-mode auto
!
interface ATM0.1 point-to-point
ip address 10.0.0.1 255.255.255.252
no ip redirects
no ip unreachables
no snmp trap link-status
pvc 0/35
vbr-nrt 320 320 1
oam-pvc manage 5
oam retry 3 5 1
encapsulation aal5mux ip
After reload bandwidth parameter changes to 320 every time. Why?
Is it normal situation for this model?
Best regards,
JM
04-11-2007 06:17 AM
In general, all routing protocol and packets sourced by the router are serviced with a higher degree of priority even if these packets fall into the default queue.
Try:
http://www.cisco.com/en/US/products/ps6558/products_ios_technology_home.html
04-11-2007 06:24 AM
OK, but my problem is - why bandwidth parameter is changing after reload, why ie. OSPF has to recalculate its metric because of changing bandwidth parameter?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide