Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

877 and bandwidth parameter change after reload

Hello,

Does anybody had a problem with bandwidth parameter change after reaload?

I have a Cisco 877 router with AdvIPSer software and such a configuration considering ATM interface:

interface ATM0

bandwidth 256

no ip address

load-interval 30

no atm ilmi-keepalive

dsl operating-mode auto

!

interface ATM0.1 point-to-point

ip address 10.0.0.1 255.255.255.252

no ip redirects

no ip unreachables

no snmp trap link-status

pvc 0/35

vbr-nrt 320 320 1

oam-pvc manage 5

oam retry 3 5 1

encapsulation aal5mux ip

After reload bandwidth parameter changes to 320 every time. Why?

Is it normal situation for this model?

Best regards,

JM

2 REPLIES
New Member

Re: 877 and bandwidth parameter change after reload

In general, all routing protocol and packets sourced by the router are serviced with a higher degree of priority even if these packets fall into the default queue.

Try:

http://www.cisco.com/en/US/products/ps6558/products_ios_technology_home.html

New Member

Re: 877 and bandwidth parameter change after reload

OK, but my problem is - why bandwidth parameter is changing after reload, why ie. OSPF has to recalculate its metric because of changing bandwidth parameter?

97
Views
0
Helpful
2
Replies