877 and bandwidth parameter change after reload

[j.merchut]

Hello,

Does anybody had a problem with bandwidth parameter change after reaload?

I have a Cisco 877 router with AdvIPSer software and such a configuration considering ATM interface:

interface ATM0

bandwidth 256

no ip address

load-interval 30

no atm ilmi-keepalive

dsl operating-mode auto

!

interface ATM0.1 point-to-point

ip address 10.0.0.1 255.255.255.252

no ip redirects

no ip unreachables

no snmp trap link-status

pvc 0/35

vbr-nrt 320 320 1

oam-pvc manage 5

oam retry 3 5 1

encapsulation aal5mux ip

After reload bandwidth parameter changes to 320 every time. Why?

Is it normal situation for this model?

Best regards,

JM

[j-block]

In general, all routing protocol and packets sourced by the router are serviced with a higher degree of priority even if these packets fall into the default queue.

Try:

http://www.cisco.com/en/US/products/ps6558/products_ios_technology_home.html

[j.merchut]

OK, but my problem is - why bandwidth parameter is changing after reload, why ie. OSPF has to recalculate its metric because of changing bandwidth parameter?