I recently bought 3 877's for a DMVPN job. On upgrading the software to ADVIPServices the router stared clicking. i.e. after the upgrade a clicking noise started to comform within the router, they click every 3secs approx.
With the smae boxes i am having DMVPN issues when they are configured as spokes of the DMVPN i am getting Bad "Refcount in Datagram_Done" errors which seen to be some sort of IOS problem. i have been through a number os IOS's and they same happens with all.
A free, open source network device configuration management tool, customizable to your needs!
- Always vote on an answer if you found it helpful
I had this here in the UK and it was due to the ADSL interface not operating correctly. I changed the "dsl operating-mode" from auto to ansi-dmt, and the ATM interface came up and the clicking stopped.
Don't know if this applies to you in your scenario, but it worked for me.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...