08-30-2012 11:10 PM - edited 03-04-2019 05:26 PM
Dear all,
my newly purchased 886VAW won't sync.
The link ( ISDN ) I'm running it off from runs nicely on my crusty-trusty 803. I linked the box
with the cables supplied against the splitter as usual but can't seem to get a stable CD light ( constantly flashing ).
The box is intended to run against ADSL (with VDSL to come in a few days ).
Can someone shed some light on what I am doing wrong ?
Controller VDSL 0 is DOWN
Daemon Status: Establishing Link
XTU-R (DS) XTU-C (US)
Chip Vendor ID: 'BDCM' 'IFTN'
Chip Vendor Specific: 0x0000 0x71B8
Chip Vendor Country: 0xB500 0xB500
Modem Vendor ID: 'CSCO' ' '
Modem Vendor Specific: 0x4602 0x0000
Modem Vendor Country: 0xB500 0x0000
Serial Number Near: C886VA-W 15.1(4)M
Serial Number Far:
Modem Version Near: 15.1(4)M
Modem Version Far: 0x71b8
Modem Status: Idle
DSL Config Mode: AUTO
Trained Mode:
TC Mode: UNKNOWN
Selftest Result: 0x00
DELT configuration: disabled
DELT state: not running
Trellis: OFF OFF
Full inits: 0
Failed full inits: 11
Short inits: 4
Failed short inits: 6
Firmware Source File Name (version)
-------- ------ -------------------
VDSL embedded VDSL_LINUX_DEV_01212008 (1)
Modem FW Version: 110506_1916-4.02L.03.B2pvC032b.d23i
Modem PHY Version: B2pvC032b.d23i
Training Log : Stopped
Training Log Filename : flash:vdsllog.bin
sho run int ATM0:
interface ATM0
no ip address
atm vc-per-vp 64
no atm ilmi-keepalive
end
interface ATM0.1 point-to-point
no ip redirects
no ip unreachables
no ip proxy-arp
ip flow ingress
pvc 1/32
pppoe-client dial-pool-number 2
!
end
08-31-2012 01:12 AM
Update VDSL firmware. Also can try configuring DSL manually.
08-31-2012 01:31 AM
All fixed - pin in Splitter torn off........
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: