Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

888 router and bounded 2 SHDSL lines conf issue

Hello to All,

i am trying to implement a 4-wire shdsl line (2 shdsl lines - bounded) to a cisco 888 router with the below configuration but the line is not getting synchronized.

controller DSL 0

mode atm

line-term cpe

line-mode 4-wire enhanced

dsl-mode shdsl symmetric annex A-B

line-rate 4608

IOS ver is 12.4(15)T7

Could you please advice on this? Do you think there are different solutions?

Thank you in advance for your time!

Tasos

2 REPLIES
Silver

888 router and bounded 2 SHDSL lines conf issue

Hi Anastasios,

You wrote that the link is "2 shdsl lines - bounded". Do you mean that the ISP is providing two different links, each with 1 pair?

Can you try to configure line-mode, dsl-mode and line-rate to auto? It is possible that the ISP is sending something different that what you configured.

Hope this helps

Marco

New Member

888 router and bounded 2 SHDSL lines conf issue

Hello Macro,

thank you for your reply,

2 different shdsl lines are terminated to my building and using a 4-wire cable these lines are bonded to one. Appropriate configuration is applied by the ISP (as i was told) at the DSLAM for this implementation. So its 2 different links (local loops) with one pair each.

i will try the auto option and i will come back.

thank you again..

663
Views
10
Helpful
2
Replies
CreatePlease to create content