I'm using a 6509 and need to enable frame-relay switching on the platform. However, after I set up the interface configuration, I canot find the "frame-relay route" command. I did enable "frame-relay switching" in the global configuration mode.
Adapter: "WS-X6182-2PA 2 port adapter FlexWAN Rev. 1.5"
Line Card: "Channelized DS3 - single wide, one port" PA-MC-T3
IOS version: 12.2(18)SXD2
controller T3 7/0/0
t1 1 channel-group 0 timeslots 1-24
t1 2 channel-group 0 timeslots 1-24
t1 3 channel-group 0 timeslots 1-24
t1 4 channel-group 0 timeslots 1-24
t1 5 channel-group 0 timeslots 1-24
t1 6 channel-group 0 timeslots 1-24
t1 28 channel-group 0 timeslots 1-24
no ip address
no ip unreachables
encapsulation frame-relay IETF
no arp frame-relay
frame-relay interface-dlci 34
What I'm planning to do is aggregate all the user data and management data from all teh sites through T1, terminate the user data(DLCI 34) and get the Authentication and get the ip address locally. Then switch the management data (DLCI 33) to another T1 (T1 28 in this case) which will be connected to the DSLAM Gateway for management.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.