i got a mission that i need to sychronous a license from an old SUP7-E to a new one, the license level is ipbase ,and it has been installed on the chassis 4507-E,then i looked up the documents from cisco.com and find a way to make a license synchronization in my case.
change the license boot level from ipbase to lanbase
no license boot level ipbase
backup the license to a usb disk
license save usb0:ipbase.lic
license save cre usb0:ipbase1.lic
then check it out to make sure its avaliability .
delete the license after reload it.
license clear ipbase
then wait the two supervisors to became a RPR mode.
install license on active SUP7-E and restore its licence boot level
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...