we have a 15 branches and 1 main branch(hub and spoke) which is running may be bgp over mpls maintained by isp so he provides us router and extra hww interfaces.but now we are going to another isp who doesnot provide to hardware like router and his hww interface ,now we need to chose which router is better and which routing is better and with mpls ,for hub location and spokes location which router and protocol better,
for hub side bandwith is 50mbps
for spoke side bandwith is 20 and 10 mbps
primary link is line
secondary link is wireless
third link is datacard
so which router , what protocol over mpls and any hardware interfaces for hub and spoke for now and if i want to increase bandwith and links for futuer purpose also
Between hub and spoke are you running dmvpn or what kid of setup is it. if it is dmvpn eigrp is the recommended protocol to run though ospf can also be used with good design, however in terms of simplicity and sclability eigrp is preffred.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...