Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

About OSPF

Hi, our HO use MPLS/VPN connect some branch office, when I type command "show route" on my HO's router, all routing info's prefix is S,there is no O, does it mean the ospf routing disabled ?? but I could see the " ip ospf " command on HO and branch office's routers. Thanks.

  • WAN Routing and Switching
4 REPLIES

Re: About OSPF

Hi,

I think you are mentioning " sh ip route " and pls see wheter you have " router ospf X " command and under that some network statements are present .

The ips in the network statement should be the ips of the wan links over which ospf is enabled .

Check " sh ip ospf neighbor " to see wheter you have any ospf neigbors . If there are ospf neighbors , then you will have some routes learned via ospf , or else you would not be able to see any routes other than static.

Hope this helps

regards

vanesh k

Hall of Fame Super Silver

Re: About OSPF

In addition to the suggestions by vanesh I believe that the output of show ip ospf would be helpful in determining whether OSPF is configured and running.

HTH

Rick

New Member

Re: About OSPF

u can use "show ip protocols as well to see which protocol is enabled........plz rate all posts

New Member

Re: About OSPF

The routes in your routing table are Static routes. it has a better administrative distance than OSPF (Static=1, OSPF=110) therefor will always appear first. You can change the admin distance of the statics to a number higher than 110 if you are sure these routes exist in ospf. You can use show ip ospf database to check if the networks exist in ospf.

Hope that helps,

Andres

99
Views
0
Helpful
4
Replies
This widget could not be displayed.