10-06-2006 06:13 AM - edited 03-03-2019 02:15 PM
Hi
I have an exchange server in my lan,
with an invalid ip address,
I want to make it avaiable via my valid ip address but I want to create a nat to access this server.
I dont know how can I write this config on my router,,please give a config hint,,regards
10-06-2006 06:35 AM
10-07-2006 12:32 AM
i was not able to open your document
10-07-2006 01:49 AM
Hi,
Check this link it should work for u.
http://www.cisco.com/en/US/tech/tk648/tk361/tk438/tsd_technology_support_sub-protocol_home.html
Configure example:
http://www.cisco.com/en/US/tech/tk648/tk361/technologies_tech_note09186a0080093f31.shtml#cfg_nat
HTH
Thanks
Raj
10-07-2006 04:52 AM
you would need a static NAT for the above scenario.
ip nat inside source static
Then add the ip nat inside & ip nat outside command on the inside & outside interface respectivley
HTH
Narayan
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide