Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

access-list counters on 3560

Hi,

I'm looking into using policy maps and class maps on a 3560. I've got 2 access-lists. When a packet matches access-list 1 I want it to be policed to bandwidth X, any other traffic should hit access-list 2 which is policed to bandwidth Y.

I *think* everything is working as it should be, but wanted to confirm this by checking the access list counters and/or by looking at debug output.

However I'm not seeing any hits against either access list, I think this is because traffic is being hardware switched.

Same goes for 'debug ip packet X'.

Does anyone know of a way to see hits against access-lists where the packet is being hardware switched, or of any other useful debug type commands that will achieve my aims?

Many thanks for any replies!

2 REPLIES
New Member

Re: access-list counters on 3560

Sorry, I should have posted this in LAN switching and routing. Will post in there, please feel free to ignore this!

Re: access-list counters on 3560

Hi

according to cisco the access-list hit counts are not seen when they are hardware switched

as far as the debug output the packets that are being fast switched are not taken into account. You may have to disable fast switching on the interface to get the debug output.

(config-if )#no ip route-cache

(config-if )#no ip route-cache cef

regards

narayan

135
Views
0
Helpful
2
Replies
CreatePlease login to create content