Please i have a voip platform for fax and voice calls,unautorised users get access via ftp.pls i need access list statement to permit only 4 ip addresses on the 2600 series and all other attempts denied.i await sample config to load on my router thanks.
If what you want is only to permit access to 4 host addresses then this access list should do it:
access-list 101 permit ip any host n.n.n.n
access-list 101 permit ip any host x.x.x.x
access-list 101 permit ip any host y.y.y.y
access-list 101 permit ip any host z.z.z.z
and on the interface:
ip access-group 101 in
where n.n.n.n, x.x.x.x, y.y.y.y, and z.z.z.z are the 4 IP addresses to which you want to give access.
I am slightly concerned that there may be things like routing updates, remote management, or other functions that may be impacted by this. But it does what you asked and permits access only to the 4 addresses. If it is too restrictive then re-statement of the requirements would be needed.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...