Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Access Server 2511 urgent Help needed

Hello All,

In an attemp to upgrade/install my AS, it took me to the shown interface instead of ROMMON,how can i get out of this interface to proceed with the installations?. The underlisted is all that shows up now when the router boots.

Thanking you all in advance

System Bootstrap, Version 11.0(10c), SOFTWARE

Copyright (c) 1986-1996 by cisco Systems

2500 processor with 14336 Kbytes of main memory

>

7 REPLIES
Hall of Fame Super Bronze

Re: Access Server 2511 urgent Help needed

You are in Rommon, please see:

http://www.cisco.com/en/US/products/hw/routers/ps233/products_tech_note09186a008009464c.shtml

HTH,

__

Edison.

Please rate helpful posts

New Member

Re: Access Server 2511 urgent Help needed

Hello,

Many thanks for your response. Unfortunately the the command was rejected.

Here is the outcome

>o/r 0x2102

What?

>

Your further assistance shall be appreciated.

Regards

Hall of Fame Super Bronze

Re: Access Server 2511 urgent Help needed

Have you tried typing 'i'

>i

What do you get?

You have to be careful, any space, though not shown will produce an incorrect command. Make sure you've typed

>o/r 0x2102 without hitting a back space and trying to delete something.

__

Edison.

New Member

Re: Access Server 2511 urgent Help needed

Thank you again sir, It's becoming very strange though, after typing the last command o/r 0x2102 the system came up with "what?" and ever since it does not even accept any further command.

No key pressed is further displayed. My terminal setting is 9600,8,N 1

Hope i can still be helped further?.

Regards

Hall of Fame Super Bronze

Re: Access Server 2511 urgent Help needed

If you are unable to type anything, I don't know what else to tell you.

Try rebooting the router and see if you can perform a ctrl+break sequence.

__

Edison.

New Member

Re: Access Server 2511 urgent Help needed

Hello, thanks you so much for your time. After rebooting the system, it now accept the commands o/r 0x2102 followed by letter "i" and now brought me to the following prompt

Copyright (c) 1986-1996 by cisco Systems, Inc.

Compiled Fri 27-Dec-96 17:33 by loreilly

Router(boot)>

Your further assistance awaited

Thanks

Hall of Fame Super Bronze

Re: Access Server 2511 urgent Help needed

Go back and read the link I provided, it will instruct you on how to load the IOS by using TFTP.

__

Edison.

Please rate helpful posts

124
Views
0
Helpful
7
Replies