10-24-2006 06:29 AM - edited 03-03-2019 02:27 PM
Hi.
I have tried to configure an ACL in a subinterface of a port-channel. But this option does not appear. The option is available for the interface port-channel or the subinterfaces of physical interfaces (gigabit,...).
The router is a 12000 with PRP and IOS ver 12.0(27)S3. The portchannel has 2 members of the same linecard (4GE-SFP-LC).
Any suggestion?
Thanks and regards.
Jose
Solved! Go to Solution.
10-30-2006 07:03 AM
It looks like Acl are not supported in a port-channel subinterface in the version this router is running.
Try this link:
10-30-2006 07:03 AM
It looks like Acl are not supported in a port-channel subinterface in the version this router is running.
Try this link:
10-30-2006 09:23 AM
Hi Beth.
You have reason, it's not supported.
In your link shows:
----------------------------------------
Feature Parity on VLAN and Stacked VLAN Subinterfaces
Starting in Cisco IOS Release 12.0(32)S, VLAN and Stacked VLAN subinterfaces on Gigabit Ethernet (ISE or E4+) member interfaces in a Gigabit EtherChannel support all software features supported on a port-channel interface, including:
?Access control lists (ACLs)
?BGP policy-map accounting (only on ingress port-channel and subinterfaces)
?Hot Standby Router Protocol (HSRP) and Virtual Router Redundancy Protocol (VRRP)
?MPLS VPN Interautonomous Systems
?Multiprotocol Label Switching (MPLS) Virtual Private Network (VPN)
--------------------------------
Thanks
Jose
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide