If you want to control traffic addressed to one of those three addresses, yes, you can do that as Paolo says, by crafting the access list according to the destination address.
If you want to control through traffic according to which IP address the remote router is routing to, then you cannot do it. The reason is that when the romote router passes you a packet, it could think it is routing through any one of those three addresses ... or even simply to the line itself. The point is that the packet carries only its original source address and its final destination address; it does not carry any information about what intermediate address the remote router thought it was routing through.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...