Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Acl's being altered by router upon entering them

Hi All,

I'm setting up a number of vpn/ipsec tunnels on a cisco 876.

When I enter the necessary acl's, I get no error, but when I check my running config, the router seems to have altered the acl.

Here's what happens:

Router(config)#access-list 111 remark *** Tunnel naar Takman Ommen ***

Router(config)#access-list 111 permit ip 192.168.26.0 255.255.255.0 192.168.28.0 255.255.255.0

Router(config)#end

Router#sh access-l

Extended IP access list 111

10 permit ip 0.0.0.0 255.255.255.0 0.0.0.0 255.255.255.0

Running the Version 12.4(15)T1.

Config attached.

2 ACCEPTED SOLUTIONS

Accepted Solutions

Re: Acl's being altered by router upon entering them

Hi,

Simply you are not matching any specific criteria here, looking at your config:-

permit ip 192.168.26.0 255.255.255.0 192.168.28.0 255.255.255.0

you are saying (I dont care about 192.168.26 at your ACL), its not a subnet mask equation, but rather its a wildcard bits match.

The correct one as bellow:

access-list 111 permit ip 192.168.26.0 0.0.0.255 192.168.28.0 0.0.0.255

HTH

Mohamed

Re: Acl's being altered by router upon entering them

I have seen this behavior and as said above it is due to the use of subnet masks instead of inverse wildcard masks while defining the access-list

These are common errors particularly if you are used to work on PIX/ASA where we do not use inverse masks

HTH

Narayan

3 REPLIES

Re: Acl's being altered by router upon entering them

Hi,

Simply you are not matching any specific criteria here, looking at your config:-

permit ip 192.168.26.0 255.255.255.0 192.168.28.0 255.255.255.0

you are saying (I dont care about 192.168.26 at your ACL), its not a subnet mask equation, but rather its a wildcard bits match.

The correct one as bellow:

access-list 111 permit ip 192.168.26.0 0.0.0.255 192.168.28.0 0.0.0.255

HTH

Mohamed

Re: Acl's being altered by router upon entering them

I have seen this behavior and as said above it is due to the use of subnet masks instead of inverse wildcard masks while defining the access-list

These are common errors particularly if you are used to work on PIX/ASA where we do not use inverse masks

HTH

Narayan

New Member

Re: Acl's being altered by router upon entering them

Briljant, On the money. I spend way to much time on ASA's.

Thank a million for putting me in my place :-)

152
Views
0
Helpful
3
Replies
CreatePlease to create content