Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Active Link Sensing in HSRP

Hi,

I am testing failover topology; here i have two redundant WAN links between Main and DR site. I have configured HSRP on both end routers where 192.168.15.10 is VIP on DR site and 192.168.15.5 is VIP at Main Site and pointed firewall towards VIP, see diagram

WAN Failover.jpg

Both ends WAN.RTR.XX have HSRP priority, so traffic passing through them, as soon sa i down the any WAN router end to end traffic fails e.g i down WAN.RTR.Main traffic didnt pass end to end where bkup routers are still up and working, so when i down other side WAN router WAN.RTR.DR, then traffic passed end-to-end.

My question is, is there any port sensing or monitoring option in routers or firewalls? when it sees that one end high priority router (WAN) get down then it automatically shut other side WAN router and all traffic takes path from bkup routers.

Best Regards

Abid Rana 

4 REPLIES
New Member

Active Link Sensing in HSRP

Hi Abid,

You need to track WAN interface in HSRP for any remote end failure sensing.

HTH,

Sukanya

New Member

Active Link Sensing in HSRP

Hi Sukayana,

Thanks for the help, it's working now. I have added following commands on both WAN routers

track 12 ip route 192.168.1x.0 255.255.255.0 reachability

interface FastEthernet0/1

standby 1 priority 120

standby 1 preempt

standby 1 track 12 decrement 30

but as soon as i down any WAN router interface, it takes 2 minutes to bring up the bkup routers but as i up the WAN router there is no interuption and traffic passed fine.

What could be the reason? is there any role of bgp as i am running bgp on WAN routers


New Member

Active Link Sensing in HSRP

Hi Abid,

Can you share the following command outputs of all 4 routers, before I can comment, whether it is related to BGP or not.

show run | sec bgp

show ip bgp

show ip route

show ip bgp summary

HTH,

Sukanya

New Member

Re: Active Link Sensing in HSRP

Hi Abid,

Alternative way to do same is with the following command

standby [group number] track [your wan interface] decrement [value with which you want to decrement]

HTH,

Sukanya

283
Views
0
Helpful
4
Replies