Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

adding banners

Can someone please show me how to add a banner "welcome" message to a router??

Is it conf t? to add it and is it one line at a time that I need to add or can I add the entire message by typing it in and cntl z, write? Here's the message I'd like to insert.

*****Your contact number is (123)456-7890

*****Welcome to the Parks Network!

*****This router is the property Parks Network

*****Use of this network device is restricted to our network team;

*****Unauthorized access and/or use is prohibited!

Thanks for help!

3 REPLIES

Re: adding banners

The syntax for the banner command is:

banner motd {char} {banner text} {char}

where the char is the delimiting character..

you can configure

config t

Banner motd #

**************************************************************************

** **

** Your contact number is (123)456-7890 **

** Welcome to the Parks Network! **

** This router is the property Parks Network **

** Use of this network device is restricted to our network team; **

** Unauthorized access and/or use is prohibited! **

** **

**************************************************************************

#

http://www.ciscopress.com/content/images/1587131595/samplechapter/1587131595content.pdf

HTH

Narayan

New Member

Re: adding banners

Thank you Narayan, Once I add this message and save it, how do I go in and modify or remove phone number or name?

New Member

Re: adding banners

Just Edit the phone number in your notepad. Then re paste your message again. In you configuration the # is the breaker. As long as you have no # within your message before the last character which marks the end of message, you should be fine

260
Views
0
Helpful
3
Replies
CreatePlease to create content