Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

additional Ethernet port for a 2611XM

Will a NM-1FE-TX work in a 2611XM? We need another Ethernet port and find that a NM-E1 is too slow. Or will a NM-1FE2W work?

3 REPLIES
Hall of Fame Super Bronze

Re: additional Ethernet port for a 2611XM

Either will work but I recommend going with the latter as the former has reached its EOL status

http://www.cisco.com/en/US/prod/collateral/routers/ps259/product_data_sheet09186a00801aa71c.html

Minimum software required 12.2(8)T - maximum modules in platform 1.

Edit: Table 3 indicates the module NM-1FE2W is only supported on 2691, thus you are out of luck in terms of support with the 2611XM

Regards,

Edison.

New Member

Re: additional Ethernet port for a 2611XM

so...the NM-1FE-TX will work but the NM-1FE2W will not?

Hall of Fame Super Bronze

Re: additional Ethernet port for a 2611XM

Neither module will work on your router.

http://www.cisco.com/en/US/products/hw/routers/ps274/products_data_sheet09186a0080091b89.html

See Table 2

You are limited to Ethernet modules..

__

Edison.

301
Views
4
Helpful
3
Replies
CreatePlease to create content