Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Adjust EIGRP Offset based on Track

I'm attaching a representation, simplified, of my scenario.

I also attached the representative configuration of the two routers in question.

Site-A is our major site (the are actually almost two sites. Different Buildings, but interconnected with Dark-Fiber).

Site-X,Y,Z are the border sites of a big mesh with almost 30 sites and more the 40 Point-To-Point Links.

Everything works fine thank to EIGRP.

(Oh god, how this is better the any other alternate routing protocol)

On Site-A, by redundancy reasons, we have two 3560-E doing Core Routing.

(I was dreaming with VSS, but our money was a little short)

I Use HSRP to provide First Hope Redundancy,

and EIGRP to solve the routing to the radio mesh.

In HSRP I use a track, based on the status of a stub LoopBack, to decrement the priority of HSRP.

With this(shuting and no-shuting this loopback on each router) I can define which one is the Active box.

It works fine...

My problem becomes when I set the secondary box as Active.

(Task that I need to do eventually, to maintenance and things like that)

The problem is that I used the command "offset" on EIGRP to define which of those 3560 would be the prefered by the routers on sites X, Y, and Z.

And when the 3560-3 is the active, traffic goes from him(3560-3) to mesh, but remains coming from mesh to standby box(3560-2).

I was looking for some alternative using a route-map or something like that.

But I couldn't find anything.

My only alternative until now is to set a pair of EMM based on syslog message of track 1 state changing.

Track 1 goes up -> Change the "off-set" to 25

Track 1 goes down -> Change the "off-set" to 50

But I really don't like this kind of solution.

I prefer something already inside of the configuration.

Does anybody has a suggestion?

Edited by: Douglas Fernando Fischer -> First time -> Adjusting translations mistakes.

Edited by: Douglas Fernando Fischer -> Second time -> Attaching Config files with the implemented solution.

  • WAN Routing and Switching
Everyone's tags (6)
1 REPLY

Adjust EIGRP Offset based on Track

Well, after several tentatives... I surrendered myself to EMM.

It works well!

I attached the implemented solution to the original question with suffix "_final".

But my afraid is related to processing capacity on my real scenario

(remembering that this scenario is representative by safety reasons)

In my real scenario I have 10 Costumers, each one in a VRF with at least 5 Interface Vlans each, and several Eigrp Neighbors in total.

669
Views
0
Helpful
1
Replies
This widget could not be displayed.