Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Adsl config

I have a Cisco 1721 router with two wic Ethernet card and one fastethernet.

I have two internet isp one lease line and another adsl line. The adsl modem is non cisco product.

Please Help me

I need both to be connected in my router so, if any of them is down then internet could not stoped. pl help me to configure the following network.

1 REPLY
Hall of Fame Super Gold

Re: Adsl config

To begin with, configure two "ip nat inside source list xx interface etethernet X overload" statements for the two int, and two default routes.

Verify that you can work the internet and both circuits are used at the same time.

After that a more advanced configuration can be done based on specific requirements.

The best would be if you can get a WIC-1ADSL card to connect directly to ADSL and eliminate the existing modem.

110
Views
0
Helpful
1
Replies
CreatePlease to create content