Re: ADSL Router supporting Multiple Public IP addresses
Just to add to Collin's post. What you need is a router that supports NAT and pretty much all routers support NAT.
As an example lets say you have been allocated 188.8.131.52/28 which means you have useable IP addresses of 184.108.40.206 -> 220.127.116.11. The ISP will use one of these for their upstream router so a common setup would be
LAN -> R1 (wan interface 18.104.22.168/28) -> ( 22.214.171.124/28)ISP router -> Internet
So you now have 126.96.36.199 -> 188.8.131.52
With these address you can host your servers. So lets say you have a server with a private address of 192.168.5.10 and you want to present it to the Internet as 184.108.40.206
1) On R1 interface connecting to the subnet(s) where your servers reside
ip nat inside
2) On R1 interface connecting to ISP router -
ip nat outside
3) On R1
ip nat inside source static 192.168.5.10 220.127.116.11
4) Allow access to this server on specific ports with an access-list on the outside interface of R1 eg
access-list 101 permit tcp any host 18.104.22.168 eq 80
5) Apply access-list
R1 WAN interface
ip access-group 101 in
That is a rough idea of the sort of thing you will need at a basic level.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...